EasyManua.ls Logo

Tyent ACE-13 - User Manual

Tyent ACE-13
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
www.tyentusa.com
MADE IN KOREA
pH Chart
If the power cord is damaged, it must be replaced by the
manufacturer, or a similarly qualified Tyent repair person in
order to avoid a hazard.
This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
·
·
·
How to Measure pH: Place approximately 2 tablespoons
(30mL) of test water in a container and add 4 drops of pH
reagent. Then, mix well and check the color of the water
with the pH chart above (The color of the water will change
according to its pH.)
The user is responsible for improper use of the
products such as use in any manner for which the
product was not originally intended and any
damage that may occur from such improper use.
This product is subject to changes that enhance
its performance without prior notification.
4.02.5 11.5
BLACK
LABEL
WATER IONIZER
This product is intended for domestic use only.
Keep this User Manual handy for easy reference.
Carefully read this User Manual, particularly “all safety warnings.”
�
�
�
User Manual
WATER FOR WELLNESS

Table of Contents

Questions and Answers

  • J
    Joseph SilvaAug 12, 2025
    How to fix Tyent Other abnormal taste?
    • M
      mary54Aug 12, 2025
      If you notice an abnormal taste in the water from your Tyent device, the first thing you should do is replace the filter.
  • A
    Angela FlynnAug 16, 2025
    What to do if the filter replacement icon remains on after replacing the filter on my Tyent Other?
    • M
      Maria DaltonAug 16, 2025
      If the filter replacement icon on your Tyent unit stays on even after you've replaced the filter, you need to reset the filter usage. Consult the manual for instructions on how to do this.
  • C
    Caitlin PowellAug 20, 2025
    Why does my Tyent Other unit stop automatically after 15 minutes?
    • J
      Jennifer MclaughlinAug 20, 2025
      Your Tyent unit is designed to stop automatically if the operating time exceeds 15 minutes.
  • T
    Timothy JamesAug 25, 2025
    Why is only purified water extracted from my Tyent ACE-13 Other?
    • D
      douglasanthonyAug 25, 2025
      If your Tyent unit is only extracting purified water, it might be due to a high flow rate (5 kgf/? or faster). You should contact us to install a pressure-reducing valve.
  • P
    Patrick GarciaAug 27, 2025
    What to do if there is settlement in extracted water from Tyent Other?
    • A
      alexgriffithAug 28, 2025
      If you notice settlement in the water extracted from your Tyent unit, it could be due to excessive calcium in the source water. Contact us for an additional filter.
  • S
    Suzanne TaylorAug 31, 2025
    What to do if Tyent ACE-13 Other leaks?
    • P
      Pamela ParkerAug 31, 2025
      If your Tyent unit is leaking, contact us.
  • J
    Jeffrey CampbellSep 4, 2025
    Why did the water outflow change in my Tyent Other?
    • I
      ireynoldsSep 4, 2025
      If the water outflow has changed in your Tyent unit, it could be due to low flow rates (less than 1?/ min). In this case, you should contact us to install a water pump. Alternatively, wait until water comes out of the water supply pipe.
  • M
    Michael ScottSep 8, 2025
    How to fix the screen turns off on Tyent Other?
    • S
      sherry02Sep 8, 2025
      If the screen on your Tyent unit turns off, check the Sleep settings in System Setup and verify the set time period. If you don't want this to happen, turn off ECO mode.

Summary

Pre-Operation Guidelines

General Safety Precautions

General safety advice to prevent danger, bodily harm, or unit damage.

Power and Installation Safety

Power Supply Safety

Precautions for safe handling of the power cord and electrical connections.

Installation Safety

Safety advice for unit placement and connection during installation.

Safe Usage Practices

Guidelines for safe operation and handling during daily use.

Cleaning and Storage Safety

Safe Cleaning Procedures

Unit Installation Guide

Faucet Installation Method

Step-by-step guide for faucet connection using a diverter.

Under-Sink Installation Method

Instructions for under-sink connection via adapter or T-valve.

Water Hose Connection

Inflow and Outflow Hose Setup

Detailed steps for connecting inflow and outflow hoses.

Drain Hose Installation

Maintenance and Filters

Water Filter Replacement Guide

Procedures for replacing primary and secondary water filters.

Filter Reset Procedure

Resetting Filter Indicators

Touch Screen Operation Basics

Touch Screen Messages and Safety

Using the Water Ionizer

Touch Screen Usage Instructions

Jog Dial Operation Guide

pH Level Settings

Alkali pH Level Adjustment

Guide to adjusting alkali pH levels via the system setup menu.

System Setup Configuration

Acidic pH and Language Settings

System Settings - Volume and Time

Volume and Time;Date Setup

System Settings - Sensor and Sleep

Proximity Sensor and Sleep Mode

System Settings - Cleaning and Display

Unit Cleaning and Turbo Function

Turbo Function for Strong Water

Troubleshooting and Warranty

Tyent ACE-13 Specifications

General IconGeneral
BrandTyent
ModelACE-13
CategoryOther
LanguageEnglish

Related product manuals