Clean truck bed thoroughly before installation. Place the assembled cover on the
truck bed against the bulkhead; make sure cover is even on all sides, then
un-buckle the safety straps.
1
Securing Front Clamps
Please refer to supplemental instruction for utility track bracket installation for
Toyota and Nissan models.
1. Pull down front clamps into vertical position. Horizontal position has been set
for optimal fitment, it still can be adjusted if necessary, please refer to Adjusting
Clamp Position section.
2. Hook jaw portion of the clamp under the metal bed rail lip. Clamp pad can be
inserted at the contact point to protect paint.
3. Turn the knob until side Q-seal of the cover is compressed and clamp is snug.
2
IMPORTANT: Clamp must make
solid contact with the metal bed
rail lip for the cover to be secure.
(See Figs 5-7 in Safety Notes)
Securing Rear Clamps and Cover
Unfold the cover all the way to the tailgate; make sure it’s even on both sides.
1. Pull down rear clamps. Horizontal position has been set for optimal fitment, it
still can be adjusted if necessary, please refer to Adjusting Clamp Position section.
2. Hook clamps under the metal bed rail lips. Clamp pad can be inserted at the
contact point to protect paint.
3. Push clamp handle down to vertical position to secure the rear latch; make
sure side Q-seal of the cover is compressed and clamps are snug.
4
Securing Safety Clamps
Turn the knob counterclockwise to loosen the safety clamp with the strap, attach
clamp to the metal bed rail lip on both side, then tighten. Must make sure safety
clamps are in direct contact with the metal part of the bed rail lips.
NOTE: Warranty will be voided if the safety clamps are not secured properly when
vehicle in motion.
3
After rear clamps have been latched securely, close/lock tailgate and cover cannot
be opened from the outside.
NOTE: Cover may not completely cover to the outside edge of the bed rails due to
slight difference in truck bed shape for different year models.
Clamp
Strap
Knob
IMPORTANT: Clamp must make
solid contact with the metal bed
rail lip for the cover to be secure.
(See Figs 5-7 in Safety Notes)
T3 SOFT TRI-FOLD COVER
Please make sure all parts are included in the package.
x1
SP-BC0004
Front Seal Strip
67” x 1.4” x 0.16”
Tool
x1
SP-BC0006
Toyota
x6
SP-BC3003
Nissan
Frontier
x6
SP-BC3005
Nissan
Titan
x6
SP-BC3004
x1
SP-BC0005
Rear Seal Strip
79” x 1.2” x 0.24”
Clamp Pad
x4
SP-BC3002
x1
SP-BC0003
Front Seal Strip
67” x 1” x 0.4”
Bed Cover
x1
DAMAGED or MISSING PARTS?
Contact us directly for replacement
www.TygerAuto.com/contact
V. 20181115
To Next Page
Need help?
General
