Tykma ELECTROX Minilase - Installing the Minilase Pro SE Software; Launching the Installer

Minilase™ e System Guide
10 | P a g e
Installing the Minilase Pro SE Software.
Before installation of the software, please make sure you have followed
steps 1-11.
After the driver installation is complete, proceed with the install of the
software.
Step 1: Locate the folder titled “Software” on the included USB drive, then
choose the folder titled “Minilase Pro SE” and double click the installer file
to launch. (MiniLase_Pro_SE_2.14.3.exe) If you receive the windows
message shown below, click “More info” and then “Run anyway”.