TYM LT600 - Loader Removal Procedure

LOADER REMOVAL
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
CAUTION:CAUTION:
CAUTION:
Tip the bucket until the bucket cutting edge
touch the ground.
STEP
STEPSTEP
STEP 6.
6.6.
6. Pull the control lever to raise the loader
until the post.
Adjust the bucket until the bottom surface of
bucket touch the ground.
STEP
STEPSTEP
STEP 7.
7.7.
7. Move the tractor backword slowly and
stop to avoid the hydraulic hoses being tighten.
STEP
STEPSTEP
STEP
8.
8.8.
8.
Stop
the
engine
and
move
the
control
Never park loader without bucket
attached to the loader.
Never allow weight of tractor to be put
on parking leg when removing loader.
STEP
STEPSTEP
STEP 1.
1.1.
1. Park the tractor and loader on hard
level surface.
STEP
STEPSTEP
STEP 2.
2.2.
2. Raise the boom until the bucket is
about 2 feet off the ground.
STEP
STEPSTEP
STEP 3.
3.3.
3. Set the parking legs with pin-hand
and Keeper.
STEP
STEPSTEP
STEP 4.
4.4.
4. Lower the boom until the Parking
legs make contact on the ground.
- 13 -
STEP
STEPSTEP
STEP 5.
5.5.
5. Remove the latch pin while move the
control lever back and forth slightly to make
the latch pin easy.
STEP
STEPSTEP
STEP
8.
8.8.
8.
Stop
the
engine
and
move
the
control
lever back and forth, left and right several times
to reduce the hydraulic pressure in the hoses.
STEP
STEPSTEP
STEP 9.
9.9.
9. Disconnect the quick couplers on the
hydraulic hoses.
STAND
STANDSTAND
STAND
PIN
PINPIN
PIN-
--
-HAND
HANDHAND
HAND
PIN
PINPIN
PIN
- 13 -