LUBRICATION
NOTICE: It is not recommended to use a preassure washer to clean the mower assembly. High pressure
water may cause damage to spindles, pulleys, belts, or bearings shortening life and reducing
serviceability.
Life of the mower depends upon the maintenance given. Proper lubrication is very important.
Always lubricate the deck and lift components before operation.
Always wipe the fittings to be lubricated with a clean cloth before greasing. Dirt injected into the fitting
will cause damage to the machined parts.
Use SAE Multi-purpose lithium base grease on all lubrication locations shown below. Remember to
wipe away excess grease, which has built up around parts.
Lubricate grease fittings after every 50 hours of operation.
Miscellaneous working parts not porvided with lubrication fittings should be oiled daily with a good
grade of lubricating ail.
To Next Page
Loading...
Need help?
General
