If the Ride on lawnmower has rolled
over or the ROPS has been dam-
aged (such as striking an overhead
object during transport), It must be
replaced to provide the original pro-
tection. After an accident, check for
damages to the 1.ROPS. 2.Seat.
3.seat belt & seat mountings. Before
you operate a Ride on lawnmower,
replace all damaged parts.
Before operating a Ride on lawn-
mower it is important to adjust the
seat to the most comfortable posi-
tion & check whether it is properly
locked in its position.
DAMAGE OF THE ROPS
WARNING
If the ROPS is removed or re-
placed, make certain that the
proper hardware is used to re-
place the ROPS and the rec-
ommended torque values are
applied to the attaching bolts.
WARNING
Do not use solvents to clean
the seat. Use warm water with
a little detergent added.
NOTE
SEAT SLIDING
WARNING
Do not weld, drill or straighten
the ROPS.
WARNING
Always wear your seat belt
if the Ride on lawnmower is
equipped with ROPS.
Never attach chains or ropes to
the ROPS for pulling purpos-
es; this will cause the Ride on
lawnmower to tip backwards.
Always pull from the Ride on
lawnmower drawbar. Be care-
ful when driving through door
opening or under low overhead
objects. Make sure there is suf-
ficient overhead clearance for
the ROPS fatal injuries.
Do not put a hand between the
seat and the slides when ad-
justing the seat position. You
can get injured unexpectedly.
CAUTION
T19O004B
Seat Belt
Forward / Backward
adjustment lever
TK0002A
To Next Page
Loading...
Need help?
General
