3-20
DESCRIPTION OF OPERATING SYSTEM
CAUTION
Do not attach a PTO shaft with the engine running and ensure all safety shields are in place.
■ Adjustment of the Yoke Rod on the Lower Link
For different applications change the position of the yoke rod on the lower link
holes as shown and insert the pin in the direction of the arrow
■ Mounting Implement
If the PTO is used, remove the safety cover off the PTO shaft.
Adjust the yoke rod on the lower links to suit the implement in use.
Attach the left lower link, then attach the right lower link using the adjusting
handle on the leveling box if required.
Attach the top link.
Attach the PTO shaft to the tractor if used, making sure that it is locked in place.
Adjust the check chains to suit the implement and tighten the locknuts.
To remove an implement reverses the procedure.
LiftRod
DANGER
Only use trailer hitch to tow and keep the 3 point linkage in raised position when towing with the drawbar.
Position can create unbalance causing the Tractor to roll-over & Result the death or serious injury.
To Next Page
Loading...
