GAP ADJUSTMENT
■ Adjusting the Clutch and Brakes
Using the clutch over a period of time will increase the free play. The correct free play of the
pedal is 20~30mm (0.78~1.18in.) To adjust, loosen the locknut on the turnbuckle and adjust.
Check the adjustment and tighten the locknut if the free play is correct. As is the case with
the clutch, use of the brakes will change the pedal free play and the balance between the
right and left pedal. The correct pedal free play is 30~40mm(1.18~1.57 in.)
- Adjusting Method
Loosen the locknuts to adjust the brake. Turn the turnbuckle counterclockwise to increase
the free play, or turn the turnbuckle clockwise to decrease. Tighten the locknut and confirm,
to fix the nuts. Check that the free play is correct and the same on both pedals to ensure
even braking.
MAINTENANCE AND SERVICE
5-16
CAUTION
An uneven adjustment of the left and right pedal will result in one sided braking when the pedals are
connected and can cause serious accidents, especially at high speeds. Double check to ensure that free
play is the same on both pedals.
■ Adjusting the Throttle Lever
If this level is either loose or difficult to move please consult your dealer for rectification of the problem.
■ Adjusting Toe-In
If the toe-in adjustment is incorrect, it can cause the severe shaking of both the steering wheel and the entire tractor. The correct
toe in is 2~6 mm (0.08~0.24 in.)
We recommend that this adjustment is made by the dealer.
Locknut Turn Buckle
Free Play
To Next Page
Loading...
