4. SERVICING MISCELLANEOUS
MAINTENANCE AND SERVICE
5-19
■ Cleaning the Air Cleaner Dust Valve
Check that the dust valve is not blocked.
Inspect the rubber flaps for cuts and nicks and check that the rubber is not perished.
Renew if necessary.
To remove dust from the dust valve, squeeze it between thumb and fingers. Wipe
around the dust valve to remove dust collected on the outside.
■ Cleaning / Changing the Element
Release the two clips on the air cleaner end cover and remove the element.
Remove dust by blowing compressed air through the element.
Check the element for damage, if necessary, change the elements.
Check all hoses for condition and tightness.
IMPORTANT
Never beat the element on a stone or concrete floor/wall to clean it.
Check all connections and hoses especially on the clean side of the air cleaner to ensure no dusty air can
enter the engine.
Check the element for flaws by putting a light inside the element.
When reassembling, make sure all surfaces seal correctly to keep dust out.
When working in dusty conditions, increase the service frequency.
Replace the element after cleaning it 5 times or if it is damaged.
5
To Next Page
