G
STANDARD FOR FARMWORK
G
▶ CAUTIONS FOR INSPECTION &
MAINTENANCE
Do not refuel either when the engine is
still hot or while driving.
Measures against a fire: Every working
place with a risk of fire should be
provided with a fire extinguisher.
Prevent a fire by taking measures such
as making a smoking area.
Always wipe off the leaked fuel.
Be seated in the cab when starting the
engine.
After refueling, tighten the fuel cap and
check if there is any fuel leakage from
tank or pipe.
When opening a cap to supply water to
radiator, be careful because steam or
boiling water may spray due to
overheating.
▶ INSTRUCTION AFTER USE
When the work is completed, stop the
engine on a leveled ground, check the
machine to clean. (remove any foreign
materials)
• Remove straws, dirt, etc. and clean
around the engine, silencer, and fuel
tank.
Lay a cover on the transplanter
(equipment) after the muffler and
engine cool down.
Get a regular inspection after the season
is over.
• When discarding a part (battery, oil,
etc.) or scrap a machine, consult to a
dealer and proceed accordingly.
For long-term storage, remove the
battery from the machine and store it or
disconnect the negative battery cable.
When loading/unloading the machine
• Choose a place with a leveled and
safe ground.
• Drive at low speed.
• Use a ramp with anti-slippery.
When entering paved road
• Use a ramp to cross a ditch or a bank.
• Make sure to use a ramp to enter/exit
a high footpath. Be careful with fall
and not to overturn.
• Check the safety around the
surrounding before starting to drive.
When driving on a slope
• Drive at the minimum speed, lower
the operating machine as low as
possible and low the center position.
5