STANDARD FOR FARMWORK
G
6
• If the safety frame was removed for
specialized work, restore it
immediately.
Be careful to touch dangerous area such
as power transmission gear, rotating
unit, etc. Put on a protective cover.
Do neither modify nor remove the safety
device.
When checking and replacing the blade
to plow the ground
• Stop the engine.
• Prevent the rotary from falling by
turning the fall adjusting handle to
stop hydraulic pressure.
• Apply the parking brake.
• Do not stand between tractor and
rotary.
When working with rotary
• Do not put your hands near the
rotating part such as blade axle and
universal joint.
Manage PTO
• Stop PTO before stopping the engine.
• Do not remove the PTO protective
cover or protective panel for
operating machine.
• Do not use PTO adaptor in order to
extend the PTO coupler or universal
joint to outside of PTO protective
cover.
To repair, secure the wheel width, or
changing the wheel under either tractor
or trailer, with the tractor or trailer
raised, choke the wheels that are on the
ground.
Do not use hydraulic jack for operating
machine or tractor. Instead, use block
or stand.
Safety frame
• Do neither weld nor drill a hole on
the attached safety frame. Also do
not modify it.
• Replace the damaged safety frame
with a new one.
When getting off the cab, turn off the
engine, lock the parking brake and
remove the ignition key.
If it is inevitable to park on a slope,
choke the wheels.
Park on a leveled and safe ground safely.
Check if the wiring code is in contact
with other parts, peeled, loosen or
having spacing.
To Next Page
Loading...
Need help?
General
