D
OPERATION
D
▶ PTO LAMP
PTO monitor lamp indicates the state of
the PTO shaft.
• If the PTO lamp glows:
The PTO is rotating.
• If the PTO lamp blinks:
The PTO is stopped but will rotates
when a implement is raised. (option)
• If the PTO lamp is off:
The PTO is off.
▶ OPERATING PTO
Follow next steps to use PTO.
1. Decrease engine speed to near idle.
2. Change PT
O shift lever to desired
position.
3. Turn on the P
TO switch.
4. Increase engine speed to desired
s
peed.
Rear PTO is provided for variable utility.
The engine will not start if PTO switch is
ON position.
The engine will shut-off if the operator
leaves the seat with parking brake
released and PTO engaged.
7
3. OPERATION OF PTO
PTO PTO speed
REAR 540 RPM
MID (OPTION) 2,000 RPM
To avoid damage of transmission and
implement, do not engage PTO with the
engine running at high speed.
Do not operate any implement at a high
speed than is specified for it.
When making adjustments to the
implement, stop the engine to avoid
serious injury.
When leaving the tractor stop the
engine and remove the key.
Apply parking brake.
WARNING
PTO SWITCH
PTO SHIFT LEVER
PTO SHIFT LEVER
To Next Page
Loading...
