EasyManuals Logo

TYM T433 User Manual

TYM T433
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
HYDRAULIC OIL FILTER AND ENGINE OIL FILTER CARTRIDGE
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by hand until seal contacts bare, then turn it 2/3
rd
turn
further to tighten it check for leaks.
Never use petrol (gasoline) thinner or similar inflammable material to wash the
primary fuel filter.
After replacing the filter always bleed the system
important
70
CHANGING THE COOLANT
(1) Open the tap in front of the gear pump to drain the coolant.
(2) Open the radiator cap at the same time.
(3) To give a thorough clean run a hose into the radiator and
flush it out.
(4) Close the tap and refill the radiator with a coolant
mixture of water and corrosion inhibitor or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes,
check the water level again and top up if required

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TYM T433 and is the answer not in the manual?

TYM T433 Specifications

General IconGeneral
BrandTYM
ModelT433
CategoryTractor
LanguageEnglish

Related product manuals