TYM T700 - Page 38

Draft Control mode light is ON
see page (48,49) for complete instructions.
Turning Control mode light is ON
see page (48,49) for complete instructions
Reverse Control mode light is ON
see page (48,49) for complete instructions
External
Control
mode
light
is
ON
External
Control
mode
light
is
ON
see page (48,49) for complete instructions
►Independent PTO
■ It must be noted that the PTO shift lever on the LHS beside driver seat should be shifted to position
1 (564 RPM) or 2 (799 RPM) depending upon the implement specification.
At no time should the speeds be changed from those specified as serious damage to the
tractor/implement to person can result because of this. When the PTO is not in use the shift
lever must be put in neutral position to avoid unnecessary use or accidental use.
Always select”NEUTRAL” before starting the engine
34