TYM T700 - Page 39

PTO monitor Lamp
■ The PTO monitor lamp on the dash panel indicates the state of the PTO shaft.
1. If the monitor glows: The PTO is rotating
2. If the monitor is off: The PTO is off
3. If the monitor blinks: The PTO is presently stationary but will
instantly start rotating when the clutch pedal is released or the implement
is lowered
Two switches operate the independent PTO.
1.PTO ON/OFF switch:
PTO ON/OFF switch is situated on the front of the
hydraulic control panel and can be identified easily with
its built in red colored indicator.
Wh th it h i h d d t t t
th PTO
is
lowered
Wh
en
th
e sw
it
c
h
i
s pus
h
e
d
d
own
t
o s
t
ar
t
,
th
e
PTO
indicator glows to indicate that the switch and the PTO
are in ON position, If the switch is pushed down again the
indicator goes off signaling that the PTO is OFF.
PTO ON,Off switch
2. PTO Control switch:
This switch is situated above the PTO ON/OFF switch.
Th th iti k d f thi it h
The PTO shaft will not rotate if either of the two switches are in the OFF position.
Th f ll i t bl l i h th PTO t t th t diff t (M l & A t )
PTO Control switch
Th
ere are
th
ree pos
iti
ons mar
k
e
d
f
or
thi
s sw
it
c
h
.
■ Off at the center
■ Manual at the left
■ Auto at the right.
Th
e
f
o
ll
ow
i
n
g
t
a
bl
e ex
pl
a
i
ns
h
ow
th
e
PTO
o
p
era
t
es a
t
th
e
t
wo
diff
eren
t
(M
anua
l
&
A
u
t
o
)
positions of the PTO control switch with the PTO ON/OFF switch in the on position.
First select the specified speed for the PTO by using the PTO shifter on the LHS, beside
the driver seat.
35