TYM T700 - Page 54

Right hand console controls
▶Controller
The electronic three point linkage hitch system consists of the operators control panel, the hitch hydraulic
control valve, the Hitch position feed back sensor ,external hitch switches, and self check system.
In position control the hitch moves by rotating the position control knob. In load control the electronic Hitch
t th hit h t i t i t t i l t l d th t t i h i il diti d
sys
t
em moves
th
e
hit
c
h
t
o ma
i
n
t
a
i
n a cons
t
an
t
i
mp
l
emen
t
l
oa
d
on
th
e
t
rac
t
or
i
n c
h
ang
i
ng so
il
con
diti
ons an
d
terrain.
▶Operation of controls
1) Lift arm(one touch Up and down) switch
This switch is used to fully raised or lower the hitch. It
has 3 working positions: Up Down and s
tationary
has
3
working
positions:
Up
,
Down
,
and
s
tationary
UP : The switch is in the ON position. This fully raises the
hitch from the working position to the transport
position. The speed is not adjustable.
Down: The switch is in the OFF position. This lowers the
hitch from the transport position to full down
(working position) or the position set with the
position control knob.
2) External hitch switches
The external switch for the 3 point hitch can be used to raise or lower the hitch from outside the tractor.
This can be useful for making small adjustments when connecting implements to the 3 point hitch.
Always operate the remote switches according to the following procedure.
STEP 1: move the FORWARD/NEUTRAL/REVERSE Lever to the NEUTRAL position, engage the
park Brake
STEP 2: to raise the hitch.
to lower the hitch.
Watch for possible pinch points
between the implement and
tractor when the hitch is moved.
Warning
Stand well clear of the linkage or Implement when operating the external controls or
injury can result from contact with moving parts. .
Warning
50