CHANGING THE OILS IN THE TRACTOR
Always use quality oils as engine or transmission oil (refer to the page 61)
Refer to the table on page 60,61 and 62 for the change frequency.
▶ Changing engine oil.
Park tractor on level surface, shut-off engine
Remove sump plug & drain oil.
Replace and check the sump plug and refill the engine
with oil to the correct level on the dipstick
(approx. 2.38 gal)
The grade of oil to be used will depend on the ambient
temperature.
The tractor is shipped from the factory with 10W/30
For summer use over 77℉ use SAE 30
For temperatures from 32℉-77℉ use SAE20 or 10W/30
For temperatures below 32℉ use SAE 10W
When changing the oil always change the filter.
Always use the same oil, as using different oils or specifications can
cause damage.
Dispose off the old oil as per local regulations.
▶ Changing the transmission oil
Remove the drain plug from bottom of the transmission and drain
the oil.
important
Replace and check the drain plug.
Refill the transmission to the correct level on the
dipstick with new oil :qty 42ℓ(11.1 US gal)
73
Always use the same grade and specified oil as replacements
Dispose off the old oil as per local regulations.
important
To Next Page
Loading...
