▶Changing Oil in the Front axle
1. Drain the oil from the center diff plug and the drain
plug in each drive.
2. Replace and tighten all drain plugs.
3.Remove the top plug(Vent plug)from each final drive to
vent air from final drives.
4. Remove the dip stick from the filter hole and fill with
4.33 US gal(16.4 liters)and allow time for the oil to
drain into the final drives.
5. Check the oil level with the dipstick and replace the
vent plugs on both final drives and tighten
Some operators have found that when they fill with the correct amount of oil and dip it,the
oil level on the dipstick is too high due to the fact that it takes a while for the oil to run
into the final drives.
Opening the Vent plugs helps to speed this up.
important
CLEANING AND CHANGING FILTERS
■ Engine oil filter
Using a filter wrench turn the filter anti clockwise to remove it.
Lightly smear the rubber seal on the new filter with oil to ensure, turn
it clockwise until the seal contacts the base and then turn it another
2/3 turn to tighten it.
■ FUEL FILTER(A)
This is the primary filter and removes water and
74
coarse dirt from the fuel. To clean it first close the tap
then remove the filter and wash it.
After replacing it bleed the air from the filter
To Next Page
Loading...
