■ FUEL FILTER (B)
This is the secondary filter .Remove the fuel filter with a
filter wrench Replace and tighten
Never use petrol (gasoline) thinner or similar inflammable material to wash the primary
fuel filter.
After replacing the filter always bleed the system (see page 71)
important
▶ HYDRAULIC OIL FILTER
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by
hand until seal contacts bare then turn it 2/3
r
,
further to tighten it check for leaks.
CHANGING THE COOLANT
(1) Open the tap in front of the gear pump to drain the coolant.
pen t
e ra
ator cap at t
e same t
me.
(3) To give a thorough clean run a hose into the radiator and
flush it out.
(4) Close the tap and refill the radiator with a coolant
mixture of water and corrosion inhibitor or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes,
75
check the water level again and top up if required
To Next Page
Loading...
