The factory has already coded 4 sensors to the monitor, and the sensors can be
re-coded accordingly to actual tires’ positions after exchanging the tires. There an
inflate code learning for re-coding the sensors.
In standby mode, press and hold"+"button and release it after the beep sound to
enter learning mode. The tire icon will flash on the LCD with "Id" letter showing the
beginning letter of the tire ID code. Short press "-" or "+" to scroll tire position
needed to re-code. Once ready, mount the sensor on to the tire valve(for external
sensor ),or inflate the tire(for internal sensor), once the sensor sensed the inflator,
the sensor will send its own ID code to the monitor and the monitor will display it's
sensor codeafter the beep sound. Repeat above steps to re-code other sensors if
needed. Pre
ss "SET" until beep sound to ensure new code completed stored into
the monitor. If press "+" and "SET" buttons together will not store any new ID and
resume to standby mode.
Example of tire icon flashing
9. Monitor Specifications
Pressure monitor range
To Next Page
Loading...
Need help?
General
