18
|
STARTING YOUR WASHER
Starting a Manual Start Unit (If Applicable)
• Rotate the fuel valve to the ‘on’ position.
• Move the choke to the ‘closed’ or ‘start’ position. Consult your
engine manual.
• Assure the throttle is pushed to the left.
• Turn key or on/off switch to on position.
• Pull recoil starter grip slowly until resistance is felt.
• Pull recoil cord briskly
• Return starter cord gently into the recoil housing.
• If the engine does NOT start, release the built up pressure by
pointing the high pressure gun in a safe direction and squeezing
the trigger.
• Repeat pulling the recoil starter cord.
• Once engine starts, move choke to the ‘open’ or run position.
Uncoil high pressure hose and
attach quick connect end of hose
to base of spray gun. Pull down
on collar of quick connect, slide
onto spray gun and let go of
collar. Tug on hose to be sure of
tight connection.
To Next Page
Loading...