TYPHOON 4000 - Starting Your Washer; Starting an Electric Start Unit

To Next Page

To Previous Page

Starting an Electric Start Unit

Tostartyourpressureblasterforthersttime,followtheseinstruc-

tions step-by-step. This starting information also applies if you have

let the pressure blaster sit idle for at least a day.

• Unit is shipped with battery cables disconnected.

• Attachpositive(red)leadrst.

• Attach negative (black) lead last.

• Rotate the fuel valve to the ‘on’ position.

• Move choke to the ‘closed’ or ‘start’ position. Consult your engine

manual.

• Assure the throttle is pushed to the left.

• Turn key to the ‘start’ position.

• Once engine starts, return key to the ‘run’ position.

• Move choke to the ‘open’ or ‘run’ position.

DO NOT run the pump without the water supply

connected and turned on.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

STARTING YOUR WASHER