16
|
Follow the Checklist Below Prior to Using the Machine
Each Time
1. Check to ensure the engine oil is at the proper level. Use SAE
10W30 Oil
2. Add fuel to the gas tank.
3. Connect and tighten the garden hose to the GHA (garden hose
inlet) connection.
** Water must be turned on prior to starting the washer, pull
the spray trigger to ensure water is moving the through the
lines and out the nozzle without any leaks before starting the
unit.**
4. Review the safety guidelines in the manual prior to starting the
unit.
If you have any issues operating the pressure blaster, call the
customer service line at 1-866-338-7519.
Always check the level of the engine oil prior to
starting the washer.
Failure to do so could cause the engine to seize if
the oil is low or empty.
Connect Hose and Water Supply to Pump Before Starting
DO NOT start your pressure washer without the
water supply turned on.
Failure to do so will result in damaging the pump
from overheating and void the warranty.
PRE-OPERATION CHECKLIST
To Next Page
Loading...