TYPHOON 4000 - Spray Tips; Applying Detergent with the Washer

26 |
HOW TO CHANGE SPRAY TIP
4. Make sure black spray tip is installed.
5. Make sure garden hose is connected to water inlet. Check that
high pressure hose is connected to spray gun and pump. Turn on
water.
You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Start engine following instructions “Starting Your Washer.”
7. Apply detergent to surface, using long, even, overlapping strokes.
8. Allow detergent to “soak in” for 5 minutes before washing and
rinsing. Reapply as needed to prevent surface from drying.
9. DO NOT allow detergent to dry on.
IMPORTANT:Youmustushthedetergentsiphoningsystemafter
eachusebyplacingthelterintoabucketofcleanwater,thenrunthe
pressure blaster in low pressure for 1-2 minutes.
Chemicals can cause bodily injury and/or property
damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergent/soaps. Follow all
manufacturers instructions.