typical GC6880 - P08 Stitch Numbers for Soft Start; P09 Automatic Constant-Stitch Sewing Speed; P10 Automatic End Back-Tacking Sewing; P11 Back-Tacking Mode Selection

Parameter Parameter Function Range Default Description
P08 Stitch Numbers for Soft Start 0-99
2 Soft Start Stitches Setting ( one unit = half stitch)
P09
Automatic Constant-Stitch
Sewing Speed
（
r/S
）
200-4000
3700
Constant-Stitch sewing speed
【
034.SMP
】
is set at
A(or when one shot signal is active)
P10
Automatic End Back-Tacking
Sewing(Can invalidate the stitch
correction function)
ON/OFF
ON
The Stitch-Correction is valid in sewing stop.
Note: Valid only whe n the
【
0.11.RVM
】
must set on B
ON: Invalid (Constant-Stitch sewing, it can automatic
continue ac tion as CD function)
OFF: Valid (Can’t continue execute CD function)
P11 Back-Tacking Mode Selection J/B
J
J
：
JUKI Mode (it will activate when machine is
stopped or running
B
：
BROTHER Mode (It will activate only the machine
is running)
P12
Start Back-Tacking Mode
Selection
A/M A
A
：
One shot to pedal, it will automatic execute Start
Back-Tacking.
M
：
Pedal-controlled and motor can stop arbitrarily
P13
Mode Selection at the end of
Start
Back-Tacking
CON/STP CON
CON
：
At the end of Start Back-Tacking, machine
continues sewing if pedal pressed or START signal on
( standing operation)
STP
：
At the end of Start Back-Tacking, machine stops
P14
Soft Sta rt
ON/OFF
ON
ON: Slow start feature is turned on. OFF: Slow start
function off.
P15
Make up pin mode
0-2
0
0: Semi-pin
；
1: a pin
P18
Stitch Balance for Start
Back-Tacking 1
0-200
0-200
131
0 200 Action gradually lag
P19
Stitch Balance for Start
Back-Tacking 2
158
P20
Mode Selection for End
Back-Tacking
A/M A
A
：
Pedal full heeling ,it will automatic execute end
Back-Tacking
M
：
Pedal-controlled and motor can stop arbitrarily
P24
Anti-pedaling pedals points;
voltage
0-1000 110
P25
Stitch Balance for End
Back-Tacking 3
0-200
0-200
131
0 200 Action gradually lag
P26
Stitch Balance for End
Back-Tacking 4
158
P28
Mode Selection for Bar-Tacking A/M A
Bar-Tacking, reverse solenoid action:
A
：
One shot to pedal, it will automatic execute
Bar-Tacking.
M
：
Pedal-controlled and motor can stop arbitrarily
P29 Tangent after braking force 1-50
20
P30 Thick material afterburner 0-100
0
P31 Shea r line afterburner 0-100
20
P32
Stitch Balance for Bar-Tacking
5
0-200
131
0 200 Action gradually lag
P33
Stitch Balance for Bar-Tacking
6
158