u-blox SARA-G3 Series - Page 26

SARA-G3 series - System Integration Manual
UBX-13000995 - R06 Objective Specification System description
Page 26 of 218
Switch ON:
• Apply VCC
If power saving is enabled
and there is no activity for
a defined time interval
Any wake up event described
in the module operating
modes summary table above
Incoming/outgoing call or
other dedicated device
network communication
Call terminated,
communication dropped
Remove VCC
Switch ON:
• PWR_ON
• RTC Alarm
Not
powered
Power off
ActiveConnected Idle
Switch OFF:
• AT+CPWROFF
Figure 3: Operating modes transition