U-Line 3000 SERIES - Product Disposal and Recycling; Risk of Child Entrapment

4 u-line.com
Middle Panel Removal
(U-3000FRAME-KIT-ICE ONLY):
1. Remove (2) cover screws.
Figure 6 Middle Panel Cover Screw Locations
2. Drill out (4) rivets with #30 (0.1285") drill bit.
Figure 7 Middle Panel Rivet Locations
3. Remove panel by pulling forward.
Frame Removal:
1. Drill out (2) rivets on opposite side from the hinge, which hold
the frame on. NOTE: Clear Ice unit will only have (1) rivet on
top flange.
Figure 8 Frame Rivet Locations
2. Remove frame by pulling forward.
3. Use these same instructions (3 – Remove the Door and Frame
starting on page
2 ) to remove the door and frame of the other
unit.
Cover Screws (2)
Rivets (4)