U-Line 95 Icemaker - Troubleshooting Common Issues; Ice Maker Not Ejecting Ice

25
NEVER attempt to repair or perform maintenance on the unit until the main
electrical power has been disconnected.
1. Will not eject ice (water frozen)
Cause Remedy
■ Control setting too cold ■ Adjust control warmer (counterclockwise)
■ Control defective (1-2 contacts open) ■ Replace control
■ Bin switch defective ■ Replace bin switch
■ Limit switch defective (open) ■ Replace limit switch
■ Ice maker assembly motor stalled ■ Replace motor
■ Broken wire in ice maker circuit ■ Repair or replace wiring
■ Water soaked cabinet insulation ■ Replace foamed cabinet assembly
■ Dirty condenser ■ Clean condenser
2. Will not fill with water
Cause Remedy
■ Water supply valve closed ■ Open water supply valve
■ Water switch defective (open) ■ Replace water switch
■ Solenoid valve defective ■ Replace solenoid valve
■ Fill tube outlet frozen ■ Replace solenoid valve and defrost fill tube
■ Broken wire in water fill circuit ■ Repair or replace wiring
3. Will not stop making ice
Cause Remedy
■ Bin switch defective (closed) ■ Replace bin switch
■ Bin arm binding ■ Lubricate bin arm pivot points or loosen
bin arm lever screw
4. Water will not stop filling
Cause Remedy
■ Water switch defective (closed) ■ Replace water switch
■ Solenoid valve defective ■ Replace solenoid valve
■ Stalled ice maker motor ■ Replace motor
■ Temperature control defective. ■ Replace temperature control
Ice maker is in continuous harvest
cycle (contacts 1-2 closed)
5. Ejector blades will not stop turning
Cause Remedy
■ Control defective (1-2 contacts will ■ Replace control
not open)
■ Hold switch defective ■ Replace hold switch
■ Defective wiring ■ Repair or replace wiring
■ Short in mold heater■ Replace heater
! !
TROUBLESHOOTING