Why is the display unstable on my U-Line H-1654?
If the U-Line Scales display is unstable, make sure that the scale is located in an appropriate place, on a stable surface and that the power supply is correct for the scale.
What to do if my U-Line Scales are not weighing correctly?
If your U-Line Scales are not weighing correctly, you should double-check the unit of weight, re-calibrate the scale, set the linearity, and check if the pan is installed correctly. Also, verify the installation and turn AU off (see Operation section).
How to fix a blank display on U-Line H-1654 Scales?
If the U-Line Scales display is blank, the scale shuts off, or will not turn on, check that power is going to the scale. Verify that the switch is turned on and the voltage going to the scale matches the power supply labels on the power module or scale. You can also remove the battery and plug the scale in. If the scale works, you will need to replace the battery.
Why can't I use the full capacity on my U-Line Scales?
If you cannot use the full capacity of your U-Line Scales, double-check the unit of weight. Also, look for any obstruction under the pan and verify the pan installation.
What to do if my U-Line Scales display 'OL' or 'FULL'?
If the U-Line Scales display shows OL or FULL, check if the pan is installed correctly and turn the scale on again.
How to troubleshoot non-linearity on U-Line H-1654 Scales?
If your U-Line Scales are not linear, look for any obstruction under the pan and verify the pan installation. You may also need to set the linearity.
Why is my U-Line Scales battery not charging?
If the battery on your U-Line Scales will not charge, verify that the batteries are rechargeable types and check if the power supply voltage is correct.
What to do if U-Line H-1654 Scales display is blank after turn-on test?
If the U-Line Scales display is blank after the turn-on test, and the error message display is locked, check if the pan is installed correctly. Then, turn the scale on again.
Guidance on environmental and placement factors affecting scale accuracy.
Instructions for correctly setting up the scale, including leveling and platform placement.
Setting and using high/low limits for check weighing with audible alarms.
Specifies the type and amount of calibration weight needed.
Procedure for calibrating the scale using zero and a single span weight.
Procedure for calibrating the scale using zero, 1/3, and full capacity weights.
Table addressing issues like blank display, OL/FULL, instability, and incorrect weighing.
Covers linearity, loading errors, battery issues, and specific error code meanings.
To Next Page
General
