Ubee Interactive Default Values and Logins
Ubee UBC1301-AA00 Advanced Wireless Voice Gateway Subscriber User Guide • March 2017 9
NAT Firewall, MAC/IP/port filtering, parental control, stateful packet inspection
(SPI), DoS attack protection, WPS/WPA/WPA2/WPA-PSK & 64/128-bit WEP
encryption
VPN pass-through and VPN end-point support (IPSec/T2TP/PPTP), TACACS or
RADIUS authentication
Device Management
Supports UAPSD (power savings)
DOCSIS, Web-Based, and XML Configuration
Tel ne t/ S S H re m o te ma na ge me nt
Firmware upgrade via TFTP
Configuration backup and restore
SNMP v1, v2c, v3 support
Syslog
WiFi Radar
Spectrum Analyzer
TR-069 capable
Physical and Environmental
Dimensions: 53 mm, 2.1” (W) x 286 mm, 11.25” (H) x 244 mm, 9.6” (D)
Weight: 1200g (2.6 lb)
Power: 100-120Vac, 60Hz, 1.2A, internal PSU
Operating Temperature: 0°C ~ 45°C (32°F ~ 113°F)
Humidity: 5~90% (non-condensing)
Optional battery supports continuous voice service during power outages; up to 8
hours standby, 5 hours talk time with 1 line active. Note: Actual performance is
affected by battery age and operating environment. Note: Battery must be fully
charged prior to first use.
1.7 Default Values and Logins
The UBC1301-AA00 is pre-configured with the default parameters for your cable service
provider.
Local Port Address: 192.168.100.1
Web Interface: http://192.168.100.1
Operation Mode: NAT Mode
Subnet Mask: 255.255.255.0
Wireless Defaults:
Default wireless encryption is WPA2-PSK with AES.
SSIDs (wireless network names) = “WIFI” plus the last 6 characters of the Cable
Modem MAC address (in upper case) for the 2.4GHz radio band. “-5G” is added to
the end for the 5GHz radio band. The SSIDs can be found on the device label.
To Next Page
Loading...
