- During dehumidifying modes, remove the drain
plug from the back of the unit, install the drain
connector (
5
/
8
universal female mender) with
3 4 hose (locally purchased). For the models
without drain connector, just attach the drain
hose to the hole. Place the open end of the
hose directly over the drain area in your
basement floor. Please refer to Fig.21 & 22.
-
When the water level of the bottom tray reaches
a predetermined level,
Carefully move the unit to a drain location,
remove the bott
om drain plug and let the
water drain away (Fig.23). Reinstall the bottom
drain plug and restart the machine until the P1
symbol disappears. If the error repeats, call for
service.
" "
the unit beeps 8 times,
the digital display area shows P1 . At this time
the air conditioning/dehumidification process will
immediately stop. However, the fan motor will
continue to operate (this is normal).
" "
Remove the
drain plug
Fig.21
Continuous
drain hose
Fig.22
Fig.23
INSTALLATION INSTRUCTIONS
12
Water drainage:
To Next Page
Loading...
