Ubiquiti edgerouter X SFP - Using the SFP Port; SFP Module Installation

Using the SFP Port (Optional)
To use the eth5/SFP port:
1. Remove the protective plug covering the eth5/SFP port.
2. Plug a fiber SFP module into the eth5/SFP port.
1000Mbps SM/SC 20KM DDM
Tx1550nm/Rx1310nm
SN: 13 0826 179
EF -10 00M -20 KM -15
3. Connect a fiber optic cable to the fiber SFP module. Then
connect the other end of the cable to another fiber device.
50
For information about compatible fiber SFP modules, visit:
community.ubnt.com/edgemax