Need help?Do you have a question about the Ubiquiti ROcket M5 and is the answer not in the manual?
General| Frequency | 5 GHz |
|---|---|
| Throughput | 150+ Mbps |
| Processor | Atheros MIPS 24KC, 400 MHz |
| Operating Temperature | -30 to 75° C |
| RoHS Compliance | Yes |
| Wireless Standards | 802.11a/n |
| Output Power | 27 dBm |
| Networking Interface | 10/100 Ethernet |
| Memory | 8 MB Flash |
| Dimensions | 160 x 80 x 30 mm |
| Wireless Approvals | FCC, IC, CE |
| Power Method | Passive Power over Ethernet (PoE) |
| Operating Humidity | 5 to 95% Noncondensing |
| Antenna Gain | 16 dBi |
| Mounting | Pole Mounting Kit (Included) |
| Security | WEP, WPA, WPA2 |
Explains how to reset the device to factory defaults by pressing and holding the reset button.
Instructions for removing the port cover and connecting the Ethernet cable to the LAN port.
Steps for attaching RF cables to Chain 0/1 and mounting the Rocket to a dish or sector antenna.
Guide on aligning and attaching the protective shroud to the Rocket for different antenna types.
Details on connecting the Rocket to the PoE adapter and the LAN to the adapter, plus connecting the power cord.
Steps to verify connectivity, configure the host system's IP, launch the browser, and log into the airOS interface.
Details on compliance, serviceability, power cord usage, grounding, and contact for installation questions.
To Next Page