Need help?Do you have a question about the Ubiquiti UniFi UAP-AC-IW and is the answer not in the manual?
General| Model | UAP-AC-IW |
|---|---|
| Wireless Standards | 802.11 a/b/g/n/ac |
| Frequency Bands | 2.4 GHz, 5 GHz |
| Maximum Data Rate | 1167 Mbps |
| Buttons | Reset |
| Power Method | 802.3af PoE |
| Supported Voltage Range | 44-57VDC |
| BSSID | Up to 4 per Radio |
| Operating Humidity | 5 to 95% non-condensing |
| VLAN | 802.1Q |
| Advanced QoS | Yes |
| Guest Traffic Isolation | Yes |
| WMM | Yes |
| Concurrent Clients | 100+ |
| Type | Indoor |
| Networking Interface | 10/100/1000 Ethernet |
| Ports | 1 x 10/100/1000 Ethernet |
| Max. TX Power | 20 dBm |
| Antennas | 2 Dual-Band Antennas |
| Antenna Gain | 2.4 GHz: 3 dBi, 5 GHz: 3 dBi |
| Wireless Security | WEP, WPA, WPA2 |
| Mounting | Wall |
| Operating Temperature | -10 to 70°C |
| Data Rates | 802.11b: 1, 2, 5.5, 11 Mbps, 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54 Mbps, 802.11ac: 6.5 Mbps to 867 Mbps (MCS0 - MCS9 NSS1/2, VHT 20/40/80) |
Details necessary hardware and software prerequisites for successful installation.
Explains network setup needs, including DHCP and controller location for proper operation.
Describes the 'PoE Out + Data', 'Reset', and 'Data' ports and the reset button functions.
Guides on securing the back plate to the wall and connecting the Ethernet cable.
To Next Page