EasyManua.ls Logo

uebe Visocor HM60 - Usage Information and Battery Management

uebe Visocor HM60
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN-10 EN-11
english
english
Operating the unitOperating the unit
C C
3. Important usage information
The measurement results of automated blood pressure mon-
        
previous exertion and general physical condition. Please pay
attention to the usage information in order to obtain accurate
readings.
Do not consume alcohol, caffeine or smoke for at least one
hour before measuring.
Rest for at least 5 minutes before taking the measurement.
Depending on the previous degree of exertion, you may
even need to rest for up to an hour.
Clear the wrist from all clothing or watches/jewellery since

the blood pressure at the place of measurement.
To attain comparable results, perform the measurement
under conditions that are as similar to each other as pos-
sible, e.g. always at the same time of day in the same place.
In order to exclude side differences and to obtain compara-
ble measurement results, it is important to always take the
measurement on the same arm. Ask your doctor which side
it is advisable for you to measure.
Do not move or talk during measuring.
Breath slowly and deeply. Do not hold your breath.
4. Inserting/replacing batteries, battery icon
Insert the batteries provided into the

cover on the left-hand side of the device
(Figure 1).
Remove the old batteries from the de-
vice and insert the new ones. Please en-
sure correct polarity (marking in battery
compartment).
Close the battery compartment again by
sliding the cover in the direction indicat-
ed by the arrow until it clicks into place

If the “Empty battery ” symbol appears on the display,
switch off the device and replace the batteries.
If the device will not be operated for more than three months,
-

the affected eye immediately with plenty of water. Seek imme-
diate medical attention.
Figure 1



   
be stored in the memory, but the date and time will need to be
reset. To do this, follow the steps below.

Related product manuals