EN-12 EN-13
english
english
Operating the unitOperating the unit
C C
5. Setting the date/time
• With the device switched off, press and
hold the SET button until the four-digit
year appears on the display (Figure 1).
Figure 1
• Press the Memory button to set the year.
-
lected year and proceed to setting the date
• Set the month with the
this with the SET button.
the same way.
6. Attaching the cuff
• Clear the wrist from all clothing or watches/jewellery since
arm as it may impair the blood pressure
at the place of measurement.
• Pull the device over your left wrist, palm
facing up (Figure 1). The distance be-
tween the palm and the cuff’s edge must
Figure 1
• Fasten the cuff using
the hook and loop fas-
7. Body posture when taking measurements
Sit at a dining table, lean your back against the backrest of the
chair and bend your arm so that your arm is exactly at heart
level. Place your feet on the ground and do not cross your legs.
Ensure that the measuring point is level with your heart. If the
measuring point is lower than the heart, the measured values
may be higher. If the measuring point is higher than the heart,
the measured values may be lower.
• It is important to keep your arm calm
and not to speak during the measure-
ment.
Please pay attention to the following:
•
cross your legs.
• Do not bend your wrist.
•
• Switch on the unit by pressing the Start/
Stop button. The full display appears
(Figure 1).
• After the device has completed its calibra-
tion against the ambient air pressure, the
8. Measuring blood pressure
Figure 1
To Next Page
Loading...
