The Remote Control (controls) can be deleted from the Alarm by holding the learn button
inside the Alarm whilst inserting the last battery, 3 beeps will be heard, this indicates the
Remote Control has been deleted successfully.
Additional Wireless Detectors:
The UltraDial GSM Alarm System can be used with additional Wireless Detectors, these
include:
• Standard (non-gsm) PIR’s.
• GSM UltraPIR Alarms.
• Door & Window Contacts.
When these detectors are paired into the same Wireless Network, when any are triggered
they will automatically trigger the UltraDial GSM Alarm (which will start to dial key-holders)
together with triggering the Sirens built into any other PIR;s
The operating range between the UltraDial and Wireless Detectors is 100 metres (line of
sight) although this can be much further when multiple units are used as each unit will relay
the signal to the nearest unit.
Additional Wireless Sirens:
The UltraDial GSM Alarm System can be used with additional Wireless Sirens, these include:
• Battery Powered Internal.
• Battery or Solar Powered Internal or External.
These Sirens would be activated by any of the Detectors working within the same Wireless
Network.
The operating range between the UltraDial and Wireless Sirens is 100 metres (line of sight)
although this can be much further when multiple units are used as each unit will relay the
signal to the nearest unit.
Programming (pairing) additional Wireless Detectors & Sirens:
Wireless accessories are programmed (paired) via the Remote Controls, when a Remote
Control is paired to the UltraDial and Wireless accessories, they will operate as one Wireless
Network. The programming (pairing method) is a similar procedure to that of the UltraDial
& Remote Control (as shown above). The principle is that ALL devices need to be paired with
ALL Remote Controls being used, examples shown below.
To Next Page
Loading...
Need help?
General