- 30 -
- 31 -
Guide of Main Menu
Problem
Does not display any message on
the front panel.
Solut ion
- Check the main power cable and check that it is plugged into
a suitable power outlet.
- Check you have switch the STB main power switch
ON at the rear of the STB.
No Picture
- See 'Does not display any message on the front panel' above.
- Check the video output port is firmly connected to the TV or VCR.
- If you are using the RF output, check that the RF lead is connected
firmly to the STB and TV/VCR.
- Check that you have selected the correct channel or Video Output
on your TV.
- If you are using the RF Output, check that you have correctly
tuned the UHF channel of the STB or TV.
- Check the brightness level of the TV.
Poor picture quality
- See 'No Picture' above.
- Check the signal level, if this is low then try adjusting the
alignment of your dish.
No Sound
- See 'No Picture' above.
- Check the volume level of the TV and STB.
- Check the Mute status of the TV and STB.
Remote Control does not operate
- Point remote control directly towards the STB.
- Check and replace batteries.
No or Bad Signal
- Check the LNB ; Replace LNB if necessary.
- Check the cable from the LNB.
- Check the position of the dish; realign dish if necessary.
- If you are using a DiSEqC 1.0 switch, check that you have
connected the LNBs to the correct connections on the switch.
- Check the 'Signal Level' and the 'Signal Quality'.
Troubleshooting
21 3 4 5 6 7 8 9
Safety
Precautions
Before
You Begin
Multi-Brand
IR Remote
Controller
Hardware
Descriptions
Connections
Guide of
Functions
Guide of
Main Menu
Troubleshooting
Specifications
7
Troubleshooting
e View Only Filtered List
Setting 'ON' :
If you sort services with any category(A~Z, Transponder, Group or CAS) in the Service List, only filtered
services will be shown on the Service List.
Setting 'OFF' :
All services will be shown on the Service List. And filtered services are highlighted with yellow color.
Digital Satellite Receiver
To Next Page
Loading...