UNEEKOR QED - Sticker Placement for Irons

2
EYEXO INSTALL GUIDE
QED IGNITE
Club Data
Sticker Placement
Irons & 5 Groove
Club Speed The speed of the club before impact.
Smash Factor The amount of energy transferred from the club head to the golf ball.
Face to Path The angle difference between Face Angle and Club Path.
Club Path The in to out or out to in movement of the club head’s geometric center at the time
of impact. Club Path is the direction (right or left) the club head is moving at impact
and is measured relative to the target line.
Face Angle The direction (right or left) the club face is pointed at impact.
It is measured relative to the target line.
1. The area where the sticker is applied differs. Depending on the number of grooves where the
length of the groove starts to reduce.
2. If there are five grooves of different sizes on the club face, attach the sticker to the top
section based on the second longest groove.
3. In this diagram, the sticker should be close to the Top Edge lined up with groove number “2.”
Make sure the pointed cut is closest to the face of the club
3
EYEXO INSTALL GUIDE
QED IGNITE
Sticker Placement
2 Irons & 6 Groove
1. The area where the sticker is applied differs. Depending on the number of grooves where the
length of the groove starts to reduce.
2. If there are 6 grooves of different sizes on the club face, attach it to the top section based on
the 2/3rd difference on the 3rd groove of the shortening grooves.
3. In this diagram, the sticker should be close to the Top Edge lined up with the 2/3rd difference
between groove “2” and “3.” Make sure the pointed cut is closest to the face of the club.
QED USER MANUAL 25
Iron