Need help?Do you have a question about the UNI-T UDP3305S-E and is the answer not in the manual?
General| Output Voltage Range (CH1/CH2) | 0-30V |
|---|---|
| Output Current Range (CH1/CH2) | 0-5A |
| Output Current Range (CH3) | 0-3A |
| Output Power (CH1/CH2) | 150W |
| Output Power (CH3) | 15W |
| Number of Channels | 3 |
| Display Type | LCD |
| Ripple and Noise (CV) | ≤ 1mVrms |
| Load Regulation | ≤ 0.01% + 3mV |
| Line Regulation | ≤ 0.01% + 3mV |
| Interface | USB, RS232 |
| Operating Temperature | 0°C to 40°C |
| Resolution (Current) | 10mA |
| Storage Temperature | -10°C to 70°C |
| Output Voltage Range (CH3) | 2.5/3.3/5.0V |
| Resolution (Voltage) | 0.01V |
Provides critical guidelines to prevent electric shock and personal injury during operation.
Details technical specifications like output ratings, regulation, ripple, and response time for the series.
Specifies voltage, frequency, power, and fuse requirements for safe and proper operation.
Guides on connecting power, checking voltage, and turning on the instrument safely.
Details how to configure and use the constant voltage (CV) output mode for the instrument.
Explains the procedure for setting up and operating the constant current (CC) output mode.
Describes how to connect channels in series for higher voltage or parallel for higher current.
Introduces timer and delayer functions for programmable output sequences and delays.
Explains how to monitor channel parameters and set alarm conditions or automatic stop modes.
To Next Page
