UNI-T UT219PV - LCD Display Layout

UT219PV User Manual
10 / 27
Short press:
With Bluetooth off: Short press to save measurement data once in UT219PV.
With Bluetooth on: Short press to start one-time recording via mobile phone.
Long press:
With Bluetooth off: Long press to save measurement data continuously in UT219PV.
With Bluetooth on: Long press to start continuous recording via mobile phone.
Note:
1. Clear the data saved in the Clamp Meter: Hold down INRUSH and press SELECT while turning on the
Clamp Meter (by turning the rotary switch), then “cLr?” appears on the LCD. Press SELECT a second time,
then “ErAS” is displayed on the LCD. When data clearing is done, “donE” appears on the LCD.
2. Maximum 999 sets of data can be saved in the Clamp Meter.
Short press to turn on/off the inrush current and peak current measurement function. For ACA and CS_A
(Flex current sensor).
Long press to turn on/off the low pass filter function. For ACV, ACA, and CS_A (Flex current sensor).
Short press to select MAX, MIN, and AVG cyclically.
Long press to exit MAX/MIN/AVG mode
X. LCD Display (Figure 4)
Figure 4