Need help?Do you have a question about the UNI-T UT219PV and is the answer not in the manual?
General| Model | UT219PV |
|---|---|
| DC Voltage (V) | 1000V |
| Resistance (Ω) | 60MΩ |
| Frequency (Hz) | 10MHz |
| Display | LCD |
| Display Count | 6000 |
| Auto Range | Yes |
| True RMS | Yes |
| NCV | Yes |
| Diode Test | Yes |
| Continuity Buzzer | Yes |
| Data Hold | Yes |
| MAX/MIN Mode | Yes |
| Relative Mode | Yes |
| Inrush Current | Yes |
| VFD Measurement | Yes |
| PV Measurement | Yes |
| Analog Bar | Yes |
| Backlight | Yes |
| Auto Power Off | Yes |
| Category | Clamp Meter |
| Temperature (°C) | -40°C to 1000°C |
| Temperature (°F) | -40°F to 1832°F |
| Safety Rating | CAT IV 600V, CAT III 1000V |
Instructions for measuring DC current using the clamp jaws, including warnings.
Steps for measuring AC/DC voltage, including warnings and LPF function.
Procedure for measuring DC power and voltage/current, with safety warnings.
Guide to measuring AC current using clamp jaws and flex sensor, with warnings.
Steps for measuring resistance, including warnings and continuity test details.
Procedures for diode and capacitance measurements, including warnings.
Instructions for measuring DC voltage in mV range, with input impedance and warnings.
Guide to measuring temperature using a Type K thermocouple, including ambient temperature warnings.
Enabling and using Bluetooth for APP connection and data communication.
Details on auto power off, buzzer sounds, and low voltage detection.
Specifications for DC current (DCA) and DC voltage (DCV, DCmV) measurements.
Specifications for AC voltage (ACV, ACV-LPF) and DC power (VA) measurements.
Specifications for AC current (ACA, ACA_LPF) and flex sensor (CSA, CSA_LPF) measurements.
Specifications for resistance, diode, capacitance, and temperature measurements.
Overview of Bluetooth software and instructions for downloading the UNI-T Smart Measure APP.
Guide on connecting and using the UNI-T Smart Measure APP for meter control and data.
Guidelines for general maintenance, cleaning, and battery replacement of the Clamp Meter.
To Next Page
