B.Setting of RS232C Serial Ports
Default of RS232C serial port for communication is set as:
Baud Rate 2400
Start bit 1 (always 0)
Stop bit 1 (always 1)
Data bits 7
Parity Odd
~ END ~
This operating manual is subject to change without notice.
RS232C Serial Port (Model UT60E)
A.RS232C Port Cable
The Meter Computer
D-sub D-sub
9 Pin Female
D-sub
25 Pin Female
Pin Name
C.System Requirements for Installing the UT60E Interface
Program
To use UT60E Interface Program, you need the following
hardware and software:
l An IBM PC or equivalent computer with 80486 or higher
processor and 640 x 480 pixel or better monitor.
l Microsoft Windows 95 or above.
l At least 8MB of RAM.
l At least 8MB free space in hard drive.
l Can access to a local or a network CD-ROM.
l A free serial port.
l A mouse or other pointing device supported by Windows.
Please refer to the included CD-ROM “Installation Guide &
Computer Interface Software” for installing and operating
instructions of the UT60E Interface Program.
35
Model UT60B/C/E: OPERATING MANUAL
To Next Page
Loading...
