10
P1 P2 P3 P4
P5
The keys from P1 to P4 can be programmed.
The multiple doses (1, 2 or 3 cups) are calculated automatically from the programming of one of
them on each box.
1 Set the machine switch to Position 0.
2
Keep the key P5 pressed and put again the machine on.
Display of Pn then Pc and Pr by pressing several times the key P5
3
Pc = CALCULATED PROGRAMMING
Insert a filter-holder ( with coffee ) into the unit
Install cups
P5 Display Pc
P1 à P4 Select the dose to be programed (2c for example)
P5 Start the infusion cycle
P5
Press again to stop when the amount of coffee desired is correct.
Display of the corresponding digital value ( from 00 to 99 )
Repeat operation at 3 for the other doses ( 2C for example)
4
Pn = DIGITAL PROGRAMMING
Quick programming without coffee and/or values carried forward on other units.
P5 Display Pn
P1 à P4 Select the dose to be programed
P5 Display of the digital value of the selected dose
P1 Increase the value
P4 Reduce the value
P5
Memorize the new value
Repeat operation at 4 for the other doses
5
Pr = MANUAL PROGRAMMING
Same proceeding as in calculated programming Pc.
The manual programming doesn't calculate the other doses (1, 2 or 3 cups), only the
programed dose is modified.
Caution: any new programming ( Pn or Pc ) cancel ALL previous programed values.
6 Wait until the program mode is automatically inactivated (from 10 to 15s), or switch off
and on again the machine.
To Next Page
Loading...
Need help?
General
