C240: about 1/4 of a turn
V2403: Tighten rmly by hand.
6. Make sure there is no oil leak from the lter mounting
area. (Add engine oil to the specied level, start the
engine and run it at idle rpm for a while.)
NOTE
When removing the filter cartridge, engine oil might
spill over the oor. Put an oil receiving pan or cloth.
■
LUBRICATING LIFT CHAIN
Apply engine oil to the lift chains using an oiler or brush.
To allow oil to enter between each pin and link plate of
the lift chain, observe the following conditions:
Loosen the chain sufciently.
•
After applying engine oil, move the mast up and down
•
at least 10 times.
NOTE
If your lift truck is used near a port or coastal area, the
lift chains might be damaged from salty breezes. After
a storm or typhoon, it is advisable to wash them with
water before lubricating in the above manner.
4-34
To Next Page
Loading...
