Page11
5-2 Voice Message Amplify
G1 Charger Amplifier supports to amplify the voice message of G1 Voice Pager as the following
steps:
Step 1. Put G1 Voice Pager on G1 Charger Amplifier.
Step 2. When G1 receives RF signal, G1 Charger Amplifier activates Speaker audio and plays voice
messages automatically.
Step 3. When user pulls out G1Pager from Charger Amplifier, Charger Amplifier stops amplifying
voice message. User can also turn off the G1 Pager to stop the amplifier.
5-3 External Equipment
G1 Charger Amplifier supports external equipment as Horn Speaker and Fire Alert Indicator. Also,
G1 Charger Amplifier can link to Unication Controller to control the power or level of external
equipments.
5-3-1 Horn Speaker
G1 Charger Amplifier support external Horn Speaker as the following steps:
Step 1. Put G1 Voice Pager on G1 Charger Amplifier.
Step 2. Link Horn Speaker Connector to Horn Speaker.
Step 3. When G1 receives RF signal, G1 Charger Amplifier activates Speaker audio and external
Horn Speaker, then plays voice messages automatically.
Step 4. When user pulls out G1Pager from Charger Amplifier, Charger Amplifier stops Horn
Speaker amplifying voice message.
Step 5. User can also turn off the G1 Pager to stop the Horn Speaker.
※ Horn Speaker Connector Pin locates on rear side, following is the definition of 4 PIN:
5-3-2 Fire Alert Indicator
G1 Charger Amplifier support external Fire Alert Indicator as the following steps:
Step 1. Put G1 Voice Pager on G1 Charger Amplifier.
Step 2. Link DIN Jack cable to Fire Alert Indicator。
Step 3. When G1 Pager receive RF signals, G1 Charger Amplifier activates Fire Alert Indicator.
To Next Page
Loading...
Need help?
General
