UNICONTROL Electronic S-SW-8 User Manual

UNICONTROL Electronic GmbH
1 /10
Freinsheimer Straße 3
D-68219 Mannheim Tel.: 0621 87982 0
www.unicontrol
-gmbh.de Fax 0621 87982 35
Manual
Object Detector
S-SW-8
02-22-2021
1 Function, Construction and Purpose .................................................... 2
2 Evaluation Unit ........................................................................................ 3
2.1 Electrical Connections .......................................................................................... 3
2.2 Sensor Electrodes ................................................................................................ 4
2.3 Configurations and Indication elements ................................................................ 5
2.3.1 SW1: Set sensitivity (relay switching point) & start calibration (SW2-2 OFF) ..................... 5
2.3.2 SW2: Setting of functional properties .................................................................................. 5
2.3.3 Indication Elements .............................................................................................................. 6
2.4 Installation ............................................................................................................ 6
2.4.1 Starting manual adjustment - switch SW2-2 to "OFF" ......................................................... 6
2.4.2 Sensitivity setting (relay switching point) ............................................................................. 6
2.5 Technical Data ...................................................................................................... 7
3 Montage & Cabling ................................................................................. 8
3.1 System arrangement ............................................................................................ 8
3.2 Electrical connections ........................................................................................... 9
4 Installation ............................................................................................... 9
Warning! Advisement about the difference between S-SW-8 and S-SW-3:
Differently of S-SW-3, the first time that S-SW-8 starts operation, an adjustment must
be triggered with empty sensor detection area. To do this, press SW1 at least 5 sec-
onds, until the LED4 lights up red (calibration started). The calibration process is
completed when LED1 flashes green. Only after that objects can enter the detection
area (relay switches on) or the sensitivity can be changed. We recommend using the
automatic sensitivity adjustment.

UNICONTROL Electronic S-SW-8 Specifications

General

Brand	UNICONTROL Electronic
Model	S-SW-8
Category	Security Sensors
Language	English