User and installation manual
Réf : 004057-02 Page : 16/17
Intervention
(to be done by qualified personnel only)
WARNING
Important: when main power switch is on position « O » (no backlight), all board is out of tension except for the
area marked « SOUS TENSION ».
WARNING
Before any intervention on the control box, cut main power supply and wait at least 15 seconds to allow proper
discharge of capacitors.
WARNING
In case of board major fault before starting intervention on cables and wiring disconnect the separation device
upstream in order to work in a completely safe way.
5.1 Maintenance
Control box doesn’t need special maintenance. User is invited to check periodically the status of control devices,
especially for remotes. Replace any control device when they show signs of malfunctions.
This is valid only for private pools. In case of commercial pools, maintenance protocol may be stricter and must be in
accordance with local regulations.
5.2 Onboard motor control during maintenance operations
WARNING
Using these buttons is strictly forbidden when not having direct sight on the pool.
During maintenance and troubleshooting operation, it is possible to operate the motor directly on control box ; this
feature must not be used if it’s not possible to see directly the pool to survey cover movements effectively.
To Next Page
Loading...
Need help?
General