What to do if the charge LED doesn't light up on my Uniden DCX 640?
If the charge LED on your Uniden Cordless Telephone does not illuminate when the handset is placed in the cradle, ensure that the AC adapter is correctly plugged into both the base (or charger for DCT6485-2 and DCT64853 models) and the wall outlet. Also, verify that the handset is properly seated in the cradle.
How to reduce noise interference on Uniden DCX 640?
To minimize noise interference on your Uniden Cordless Telephone, keep the handset away from potential sources of interference such as microwave ovens, computers, remote control toys, wireless microphones, alarm systems, intercoms, room monitors, fluorescent lights, and other electrical appliances. Alternatively, try moving to a different location or turning off the source of the interference.
Why is Caller ID not displaying on my Uniden DCX 640 Cordless Telephone?
If the Caller ID is not displaying on your Uniden Cordless Telephone, it might be because the call was placed through a switchboard. Contact your local telephone company to confirm that your Caller ID service is active and current.
What to do if I cannot access remote call-in features on my Uniden DCX 640?
If you're unable to access remote call-in features from another touch-tone phone with your Uniden Cordless Telephone, first, double-check that you are using the correct PIN number. Secondly, ensure that the touch-tone phone you are using can transmit the tone for at least two seconds. If it cannot, try using a different phone to access the features.
How to enable time stamp on Uniden Cordless Telephone?
To hear the time stamp, ensure you have set the time on your Uniden Cordless Telephone. Refer to the section "Setting Day and Time" on page 26 or "Setting the Time" on page 54 for instructions.
General| Brand | Uniden |
|---|---|
| Model | DCX 640 |
| Category | Cordless Telephone |
| Language | English |
Guide to installing the battery pack and initial charging.
Steps to connect the base unit to a phone line and power outlet.
Identification and function of all buttons on the cordless handset.
Steps for choosing location, installing battery, and connecting the base unit.
Procedures for handling incoming and outgoing calls using handset and base.
Adding numbers, names, distinctive rings, and speed dial information.
Understanding incoming call information and call waiting ID services.
Recording greetings, setting ring time, record time, and alerts.
Information on supporting up to 4 handsets and connecting chargers.
Step-by-step guide to pairing new handsets with the base unit for operation.
Solutions for problems like no charge LED, weak audio, and call connectivity.
Essential safety guidelines for using the telephone equipment.
To Next Page
