Need help?Do you have a question about the Uniden Remote VFO 8010 and is the answer not in the manual?
General| Brand | Uniden |
|---|---|
| Model | Remote VFO 8010 |
| Category | Transceiver |
| Language | English |
Details unique features like drift-free oscillation, hybrid dial, dual R.I.T., segment switching, and crystal control.
Switch to change between VFO and crystal oscillator (fixed channel) modes.
Activates Receiver Incremental Tuning (R.I.T.) and indicates circuit status with an LED.
Selects crystal oscillation frequencies for channels A through J.
Illuminates when the R.I.T. switch is activated.
Adjusts receiver frequency ±5 kHz (WIDE) or ±1 kHz (NARROW).
Selects 100 kHz frequency segments on each band.
Adjusts the resistance of the tuning knob rotation.
Changes VFO frequencies across the full 100 kHz range at a 4:1 ratio.
Indicates dial reading below 100 kHz, controlled by the tuning knob.
Shows the 100 kHz order selected by the segment switch.
Indicates when the remote VFO is active during transmission or reception.
Used with the transceiver for calibrating the VFO dial pointer position.
Details on connecting the VFO and transceiver via a single cable for operation.
Explains how to use the VFO with the transceiver's function switch for different modes.
Explains how dial readings correspond between the transceiver and remote VFO.
Describes using ten crystal-controlled fixed channels for operation.
To Next Page
